Matte Silver SB | Foil 12.5"x 25ft

PLEASE READ ALL INFORMATION FOR THIS FOIL BEFORE ORDERING.

IT IS APPLIED DIFFERENTLY TO FABRICS AND NEEDS AN ADHESIVE (EasyWeed Adhesive). ADHESIVE PURCHASED SEPARATELY.

Metallic Foil Transfer is a special eye-catching graphic effect for T-shirts. It produces a shiny “metal-appearing” surface on various types of fabrics by using a heat press or home iron.

Heat Transfer Foils can be applied using a 'cuttable adhesive' such as Siser EasyWeed Adhesive or Specialty Materials HotMelt.

  • Cut Design from Adhesive Vinyl in reverse

  • Weed excess material

  • Preheat garment for 2-3 seconds

  • Apply design cut from adhesive vinyl at 275°F/135°C

  • Use medium pressure for 5-10 seconds

  • Peel carrier hot

  • Cut Design from Adhesive Vinyl in reverse

  • Weed excess material

  • Set iron dial between Cotton and Linen

  • Cover design with a non-stick reusable cover sheet or parchment paper

  • Place on flat hard surface (ironing board not recommended)

  • Press iron with medium/firm pressure (do not slide iron)

  • Press each section of design for 10-15 seconds

  • If areas of design lifts after application, replace cover sheet and re-press for 5 seconds

  • Peel carrier hot

  • Trim the foil 1/2" to 1" inch bigger than the designed image

  • Place foil over top of the image / must be applied shiny side up.

  • Cover Foil with non-stick reusable cover sheet.

  • Heat press 10-15 sec. at 300-325° F / Medium even pressure

  • Cool Peel Foil / Rub with a cloth, let cool completely, then peel.

  • Wait 24 hours after application to wash

  • Do not dry clean

  • Machine wash normal cycle, cold/warm with mild detergent

  • Lay flat to dry or machine dry on low/normal setting

  • Do not use chlorine bleach