Amethyst V2 | Foil 12.5"x 25ft
Amethyst V2 | Foil 12.5"x 25ft
Regular price
$5.96 USD
Regular price
$7.95 USD
Sale price
$5.96 USD
Unit price
/
per
PLEASE READ ALL INFORMATION FOR THIS FOIL BEFORE ORDERING.
IT IS APPLIED DIFFERENTLY TO FABRICS AND NEEDS AN ADHESIVE (EasyWeed Adhesive). ADHESIVE PURCHASED SEPARATELY.
Metallic Foil Transfer is a special eye-catching graphic effect for T-shirts. It produces a shiny “metal-appearing” surface on various types of fabrics by using a heat press or home iron.
Heat Transfer Foils can be applied using a 'cuttable adhesive' such as Siser EasyWeed Adhesive or Specialty Materials HotMelt.
Instructions for Adhesive Vinyl: (Heat Press)
• Cut Design from Adhesive Vinyl in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design cut from adhesive vinyl at 275°F/135°C
• Use medium pressure for 5-10 seconds
• Peel carrier hot
Instructions for Adhesive Vinyl: (Home Iron)
• Cut Design from Adhesive Vinyl in reverse
• Weed excess material
• Set iron dial between Cotton and Linen
• Cover design with a non-stick reusable cover sheet or parchment paper
• Place on flat hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lifts after application, replace cover sheet and re-press for 5 seconds
• Peel carrier hot
Application Instructions of Textile Foil: (HTV textile foil)
• Trim the foil 1/2" to 1" inch bigger than the designed image
• Place foil over top of the image / must be applied shiny side up.
• Cover Foil with non-stick reusable cover sheet.
• Heat press 10-15 sec. at 300-325° F / Medium even pressure
• Cool Peel Foil / Rub with a cloth, let cool completely, then peel.
Care instructions:
• Wait 24 hours after application to wash
• Do not dry clean
• Machine wash normal cycle, cold/warm with mild detergent
• Lay flat to dry or machine dry on low/normal setting
• Do not use chlorine bleach
Same foils used by Screen Printers.